Re: [squid-users] allowing z39.50 access on port 210

Hi,

The SSL_safe port is not working.

I've to enable SOCKS V4 OR Z39.50 protocol to be enabled.
Can someone tell me how to do this?

- Sameer

On Mon, Jan 19, 2009 at 4:19 PM, sameer shinde <s9sameer_at_gmail.com> wrote:
> On 1/19/09, sameer shinde <s9sameer_at_gmail.com> wrote:
>> On 1/18/09, Amos Jeffries <squid3_at_treenet.co.nz> wrote:
>> > sameer shinde wrote:
>> >
>> > > On Sat, Jan 17, 2009 at 4:26 PM, Amos Jeffries <squid3_at_treenet.co.nz>
>> > wrote:
>> > >
>> > >
>> > > > By the sounds of it you need to open CONNECT access to that port.
>> > > > Safe_ports by itself is not quite enough.
>> > > >
>> > > > Amos
>> > > >
>> > >
>> > > the default acl CONNECT method CONNECT is working there. I'm just
>> > > adding some more ports into the acl list
>> > > so that I can use some more ports. Isn't that sufficient? If No, then
>> > > how to open the CONNECT access.
>> > > (anyways I'm googling for it)
>> > >
>> > > - Sameer.
>> > >
>> >
>> > Is uses SSL_ports, not the Safe_ports. I expect 210 is needed in both lists.
>>
>>
>> I've added the port 210 in SSL_ports list & reconfigured/ restarted
>> squid3, but still i'm not able to access the site from application.
>>
>> Can you tell me where am I going wrong?
>> my entry in squid.conf for SSL port is as follows
>> acl SSL_ports port 210
>>
>
Received on Tue Jan 20 2009 - 12:23:02 MST