Re: SNMP

Henrik,

I just want to make sure. If my MRTG run in the box that using IP
202.90.140.36, then I should change the squid.conf to be:

snmp_incoming_address 202.90.140.36
#snmp_outgoing_address 0.0.0.0

Is that correct?

Please advise. Thx

Best Regards,

Awie
awie@eksadata.com
PT. EKSADATA INTISOLUSI
Phone : (62-361) 261514
Mobile1 : (62-82) 3610369
Mobile2 : (62-818) 346241
----- Original Message -----
From: "Henrik Nordstrom" <hno@hem.passagen.se>
To: "Awie" <awie@eksadata.com>
Cc: <squid-users@ircache.net>
Sent: Sunday, October 22, 2000 5:52 PM
Subject: Re: SNMP

> Last time I looked cfgmaker could only handle routers.
>
> 0.0.0.0 is not an address.
>
> The note is confusing. It should read:
>
> Note: If you want both incoming and outgoing to be the same address then
> leave snmp_outgoing_address at 0.0.0.0 and only set
> snmp_incoming_address.
>
> --
> Henrik Nordstrom
> Squid hacker
>
>
> Awie wrote:
> >
> > Henrik,
> >
> > Sorry to ask you more questions. I tried to monitor Squid with MRTG.
> > However, I found that Squid not responding to cfgmaker of MRTG. Below
> > my SNMP configuration:
> >
> > acl users src 202.91.140.0/255.255.255.192
> > acl squidsnmp snmp_community squid
> > #snmp_port 3401
> > snmp_access allow snmpsquid users
> > #snmp_incoming_address 0.0.0.0
> > #snmp_outgoing_address 0.0.0.0
> >
> > The IP addr of Squid is different from IP addr of MRTG.
> >
> > Should I change the address of snmp incoming & outgoing ? I am afraid
> > to change the address because I read a note in original squid.conf (as
> > below):
> >
> > NOTE, snmp_incoming_address and snmp_outgoing_address can not have the
> > same value since they both use port 3130.
> >
> > Please advise. Thx
> >
> > Best Regards,
> >
> > Awie
> > awie@eksadata.com
> > PT. EKSADATA INTISOLUSI
> > Phone : (62-361) 261514
> > Mobile1 : (62-82) 3610369
> > Mobile2 : (62-818) 346241
>
> --
> To unsubscribe, see http://www.squid-cache.org/mailing-lists.html
>

--
To unsubscribe, see http://www.squid-cache.org/mailing-lists.html