[squid-users] One squid for multiple cisco-routers

Dear list,

I'm trying to get squid running with two cisco-routers, but after a lot of
trial, I'm on the brink of nonsense... The two cisco-routers are a 2600
and 3800, both in the same sub-net, connected to a squid-proxy (2.6) over
wccp2 and gre. If I try to use the proxy from either cisco-router, there
is no problem. But if I try to use the proxy from both routers, the proxy
is visible to the routers, but "not usable". I change from one
configuration to the other by using one or two "wccp2_router"-lines.

Debugging the issue with debug_options 80,9 shows that only one of the two
routers is replying, but not the other one, and that the replies are of a
different length (only 136 bytes) than when it works with only one router
(180 bytes).

Is there anything I can do to test this issue further? I would really like
to get this configuration going, but I'm really lost for the moment. Could
it be something with the GRE-tunnel? One router works whether I set the
tunnel up or not, and both tunnel work neither with the GRE-tunnel,
neither without.

I hope I make sense ;)

Linus
Received on Mon Feb 16 2009 - 16:15:23 MST